Nasty SOBs

[BHC]

Just received them in today's mail, they are nasty,  extremely sharp

 

[rgw]

What is cutting diameter 

[JHbowhunter]

[BHC]

3 minutes ago, rgw said:

What is cutting diameter 

https://swatbroadheads.com/products/swat-crossbow-magnum-xmag-stx-100-grain-3-pack

[smittty]

Awesome broadhead keep in mind on them longer shots they are very loud 

[BHC]

The noise comes from vented broadheads not these

Edited April 2 by BHC

[BHC]

better pictures with them open

 

[vdep217]

I prefer a cut on contact tip.  I want a regular broad head up front such as tge rockymountainswitchblade or grave digger than 2 expandables this way I know even if it dosnt open I have at least a regular cut

[archer36]

Nothing new here. The design is almost identical to the Truglo Titanium 4 blade mechanical. That head was the "thing" a few years ago. Everyone raved about them. 

It was just the flavor of the week. New broadheads come on the market all the time. Nothing new can really be developed. It's been played out. 

The way broadheads can get better is be made stronger so they can withstand the high forces of the high FPS bows. 

The Swats are the current "flavor of the week". They are great heads. Until something "new" comes along. 

If you been around as long as me, you will remember when Slick Tricks were the "cat's meow" among archers. That ran it's course and something took it's place. 

I use at least one or two different heads a year just so I can see if there is a big difference in them. 

So far, I have not found the "magic bullet". The key is shot placement. If a deer dies in 15 seconds instead of 20, is that really a big deal?

It can only be so dead. 

 

 

 

 

Edited April 3 by archer36

[3Blade]

Yep, they look nasty. Should put a nice hole in them👍🏼

[bushden]

I prefer something a little more traditional.

[barrike]

I see it has 3.75" of total cut, but what is the cutting diameter?  Must not be very big, since it's not mentioned anywhere.  Looks cool though.

Edited April 4 by barrike

[BHC]

2” entry and 1.75” secondary blades

[vdep217]

These might be my next as the retention is better than just an o ring

Edited April 4 by vdep217